How to Change the Oil on a 50cc Tao Motor Scooter

How to Change the Oil on a 50cc Tao Motor Scooter

How to change the engine oil on a Tao Motor Scooter

Regular maintenance is crucial for keeping your 50cc Tao Motor Scooter in optimal condition. One essential task is changing the oil. By following a few simple steps, you can easily change the oil on your scooter and ensure its longevity and performance.

Step 1: Gather the necessary tools and materials

  • Oil pan or container
  • New oil filter
  • Socket wrench
  • Funnel
  • Shop towels

Step 2: Prepare your scooter

Park your scooter on a level surface and make sure the engine is cool. This will prevent any accidental burns during the oil change process.

Step 3: Locate the drain plug

Locate the drain plug underneath your scooter's engine. Consult your owner's manual if you are unsure about the exact location.

Step 4: Drain the old oil

Place your oil pan or container beneath the drain plug and use a socket wrench to loosen it. Allow the old oil to drain completely. This may take a few minutes.

Step 5: Replace the oil filter

Remove the old oil filter using a wrench or your hands. Be prepared for some residual oil to come out. Take note of the position of the old filter to ensure proper installation of the new one. Apply a thin layer of new oil to the rubber gasket of the new filter and install it in place. Ensure it is tightened securely.

Step 6: Refill with fresh oil

Using a funnel, carefully pour the recommended type and amount of fresh oil into the oil filler hole. Check your owner's manual for the specific oil grade and quantity. Be cautious not to overfill. It is better to add a little less oil and then top it up if needed.

Step 7: Check the oil level

Start your scooter and let it idle for a few minutes. This will allow the oil to circulate throughout the engine. Park it on a level surface and check the oil level using the dipstick. If the level is below the recommended range, add more oil as necessary. However, if the level is above the upper limit, drain a small amount of oil until it reaches the correct level.

Step 8: Clean up and dispose of old oil

Wipe off any spilled oil using shop towels or rags. Ensure the drain plug is tightened securely to prevent leaks. Dispose of the old oil and oil filter properly at a local recycling center or an auto parts store that accepts used oil.

Tips and Precautions

  • Always wear gloves and protective eyewear when working with oil.
  • Consult your owner's manual for the recommended oil type, oil filter, and oil capacity for your specific 50cc Tao Motor Scooter model.
  • It is recommended to change the oil and oil filter every 1,000 miles or as per the manufacturer's instructions.
  • Ensure the scooter is on a stable and level surface to prevent accidents.
  • Avoid over-tightening the drain plug and oil filter to prevent damage.
  • Keep used oil and oil filters separate from household waste and dispose of them responsibly.

Additional Considerations

While changing the oil on your 50cc Tao Motor Scooter, there are a few additional steps you can take to ensure optimal performance and longevity.

1. Inspect the air filter

Check the condition of your scooter's air filter. If it appears dirty or clogged, replace it following the manufacturer's instructions. A clean air filter allows for better air intake and improves engine performance.

2. Check the spark plug

Inspect the spark plug and clean or replace it if necessary. A well-maintained spark plug ensures proper ignition and fuel efficiency.

3. Lubricate moving parts

Apply a small amount of lubricant to moving parts such as the throttle cable, brake levers, and kickstand pivot point. This helps prevent rust and ensures smooth operation.

4. Check tire pressure

Regularly check the tire pressure and ensure they are inflated to the recommended levels. Proper tire pressure improves handling and extends tire life.

5. Inspect the drive belt

Inspect the drive belt for signs of wear or damage. If necessary, replace it following the manufacturer's instructions. A worn-out drive belt can lead to decreased performance and potential breakdowns.

Conclusion

Changing the oil on your 50cc Tao Motor Scooter is a straightforward process that can be done at home with basic tools. By following these steps and adhering to your scooter's maintenance schedule, you can keep your scooter running smoothly and enjoy many miles of trouble-free riding. Regular oil changes, along with additional maintenance considerations, will help maintain engine performance, reduce wear and tear, and extend the lifespan of your scooter.

Back to blog